ADLINK Technology cPCI-6765 Bedienungsanleitung PDF herunterladen (Seite 56)

6U Power Supply Unit

PICMG 2.11 47-Pin Hot-Swap Redundant 6U CompactPCI 8HP 400W Power Module

cPS-H640

cPS-H640/AC, H640/48

Features

• PICMG 2.11 CompactPCI Power Interface compliant

• 6U CompactPCI 8HP form factor

• PICMG 2.11 47-pin CompactPCI in-rack power module interface

• 400W DC output, maximum 480W peak output

• Active PFC (Power Factor Correction) meet IEC1000-3-2 Harmonic Correction

• Internal OR-ing Diodes for N+1 redundancy

• Hot swappable

• Active current sharing

• EMI meet EN 55022 & FCC Class A

• Supports remote ON/OFF

• Supports power failure signal & degradation signal

Specifications

Ordering Information

M o d e l n u m b e r D e s c r i p t i o n / C o n f i g u r a t i o n

cPS-H640/AC PICMG 2.11 47-Pin Hot-Swap Redundant 6U CompactPCI 8HP 400W Power Module with Universal AC Input

cPS-H640/48 PICMG 2.11 47-Pin Hot-Swap Redundant 6U CompactPCI 8HP 400W Power Module with 36~72VDC Input

Model Name cPS-H640/AC cPS-H640/48

PICMG Standards PICMG 2.11 CompactPCI Power Interface Compliant

Form Factor 6U cPCI (233.33x160mm), 2 slots (8HP) wide

Input Voltage 100-240 ± 10% VAC 36-72 VDC

Input Frequency 50-60 ± 5% Hz DC

Input Current 5.1A@115VAC / 2.5A@230VAC 12A@48VDC

Inrush Current < 30A@230VAC N/A

Power Factor Correction Typical 0.97-0.99

(PFC, only for AC) Meet Harmonic Correction IEC1000-3-2

Output Voltage/Current 5V: Typ. 40.0A, Max. 50.0A

3.3V: Typ. 20.0A, Max. 40.0A

+12V: Typ. 10.0A, Max. 15.0A

-12V: Typ. 2.0A, Max 5.0A

Max. load is the continuous operating load of each rail. But the max. load of each rail can not be drawn from all outputs at the same time

Output Voltage Minimum Load 1.0A@+5V

Output Wattage Typical 400W continuous, maximum 480W peak output

Line Regulation Typical 0.1%

Load Regulation Typical ± 1-3%

Ripple 50mV @+5V and 3.3V outputs; 120mV @+12V and -12V outputs

Hold-up Time 10mS after power fail signal

Efficiency Typical 79-83%

Output voltage sense and Available at 5V, 3.3V and +12V outputs

current sharing

N+1 Redundancy Installed with internal OR-ing diodes at all outputs for N+1 redundancy operation

Remote ON/OFF Available at [INH#] & [EN#]

Power Failure Signal Available at [FAL#] pin

Power Degradation Signal Available at [DEG#] pin

Protections Over Temperature Protection (OTP): 70˚C

Over Current Protection (OCP): Installed at each rail

Over Load Protection (OLP): Typical 120% max. load , fully protected against output overload or short circuit.

Over Voltage Protection (OVP): Built-in at all outputs

Status LED <Green LED> [POWER] means valid input voltage

<Amber LED> [FAULT] means a critical fault

Earth Leakage <0.9mA @230VAC N/A

Operating Temp. 0 to 70˚C (0 to +40˚C at full load with specified air flow. Derates linearly to 50% at +70˚C.)

Storage Temp. -20 to +85˚C

Humidity 20% to 90% non-condensed

Shock 15G peak-to-peak, 11ms duration, non-operation

Vibration Operation: 1.88Grms, 5-500Hz, each axis

Cooling Requirement Min. 20 CFM is required for typical full rating power

Certificate or Safety IEC950, EN 55022, FCC Class A, IEC60950 Class I

CompactPCI Solutions

Note: All specifications are subject to change without further notice.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 113 114

Kommentare zu diesen Handbüchern

Keine Kommentare

ADLINK Technology cPCI-6765 Bedienungsanleitung Seite 56

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Server Barebones ADLINK Technology cPCI-6765